How to Avoid Common Mistakes when Installing Metal Roofing

When selecting a metal roofing material and installing the panels on your home, there are many common mistakes that are easily made. Pay close attention to how you install your metal roof panels and be sure to consult this list thoroughly prior to beginning.

Metal Roof Installation

Incorrect Panel Lapping

Installing panels the wrong way is a common mistake that many first-time roofing installers make. Remember, to consult the material supplier on how to install panels correctly. Good suppliers will have video tutorials and printed documentation on installation of their product.

Screwing a Set Incorrectly

Every screw needs to be set correctly. The last thing you want is for them to be too tight or too loose. Always put screws where it is flat in the middle of the panel. If they’re wobbling, check to make sure that your nut driver is in proper working condition.

Don’t use Too Much Sealant

Don’t use sealant or caulk to fix a mistake on your roof. The goal needs to be to waterproof through correct installation and not by covering lazy mistakes with caulk. Any sealant should be a secondary consideration when it comes to waterproofing. When applied, it needs to be under panel or trim where it is protected from the elements because it will last longer there.

Always Measure any Panel Twice prior to Cutting

After a metal roof panel is cut, it can’t be put back together again. The last thing you want to do is measure wrong. Always ensure that you check twice, and then cut. This will keep errors to a minimum at least as it pertains to cutting. Also, ensure you are adequately planning for any penetrations i.e. skylights, attic fans, PVC piping, etc. These require special attention to properly trim and install around these openings.

Assuming Installation is the same for Every Metal Roof

Though some may be similar, always check the instructions prior to installing any metal roof. Depending on the type of panels, special attention may need to be applied to certain areas. Remember, there are varying thicknesses, finishes, and profiles. These factors in addition to the style of the property will be what determines installation.

Over the Edge Paneling is a No-No

Don’t let the metal panel hang over the edge of the roof. Though many may attempt to do otherwise, when you are properly installing a metal roof, it is recommended to ensure paneling only hangs an inch and a half to two inches extending over the edge.

Not enough Screws in your Pipe Flashing

Any penetration in the roof is an area prone to leaking. Pay close attention to how you address penetrations like PVC piping. By only laying in a couple screws and some caulk, that’s not enough to get the job done long-term. The caulk will eventually wear out and then, you’ll have a leak in no time. When installing, ensure sealant is installed underneath the base and that enough screws are placed into the base to keep it in place.

Installing a metal roof is a big project for anyone. Be sure to avoid these common mistakes that have befallen others in the past. Be highly attentive when installing metal roofing as even a minor mistake can require significant re-installation or long-term costs down the line when a leak becomes present.

Latest Trends of DIY Steel Roofing in Ontario

2017 is proving to be a record year for steel roofing. A number of Ontario property owners are choosing steel roof panels over lesser roofing materials, for a wide array of different reasons.

Meanwhile, the province’s home improvement and construction markets have been experiencing high economic growth across the regions of Toronto, Chatham, the GTA, and all across Ontario. Keeping this in mind, the latest trends in DIY steel roofing in Ontario reveal several promising discoveries that show a bright future for steel roofing later this year!

Higher Spending in DIY Home Improvement

According to indicators of home improvement activities in North America, home improvement spending has been experiencing a steady rise year over year throughout the decade.

Today, homeowners are likely to spend more money on roofing than ever before. Though all homeowners are working within budgetary limits, steel roofing is an ideal selection as not only is it not that expensive but the slightly higher front-end investment ensures that your property is equipped with a roof lasting up to 50 years and more!

More Popularity in Energy-Efficient Materials

Property owners in Ontario are searching for ways to recoup their home improvement investments in energy-efficient solutions that will save them on those expensive electricity bills year-round.

Steel roofing is a major draw for this reason. Steel roof panels in Ontario provide on average 25 percent in energy savings, compared to traditional asphalt shingles, making it a very smart choice for anyone concerned with energy efficiency.

Choosing the More Long Lasting, Sustainable Option

Consumers in Ontario are looking towards more sustainable roofing solutions. Made from recyclable materials and providing a long-lasting life span, a homeowner should not have to replace their roof for decades, no matter the weather. Other materials are not as fortunate to be able to offer these advantages. For example, take a couple of heavy Ontario winters back to back, and the wind and ice might be enough to require a partial or full replacement of a traditional asphalt shingle roof.

More Growth in Solar Panels

Every year throughout the past decade, use of solar panels in Ontario has been gradually growing. There is far more growth in the solar panel industry than many have let on. Many homeowners are seeking ways to install solar technology on their roofs, to assist in lowering expensive power bills.

This is where having steel roof panels in Ontario provide benefit. Solar panels need to be attached to a property’s roof and the presence of asphalt shingles can be tough because the installation of these panels oftentimes puncture the shingles. This leaves a property owner with a flawed roofing setup, releasing heat in the winter and potentially causing damage as moisture seeps in.

Steel roofing offers a better surface, guarding against penetration and also lasting twice as long, thereby ensuring homeowners are confident that their solar panels are being properly supported.

DIY Roofing in Ontario is About Adding Value!

So much of 2017’s trends in DIY roofing in Ontario are focused on adding value. That’s one thing that steel roofing does better than any other material. Durable, energy efficient, environmentally friendly, trendy in appearance, and adding on average an increase of up to six percent in value, steel roofing is more than worth the price.

7 Advantages of Steel Roof Installation

There are many advantages of steel roof installation and choosing steel as your roofing material instead of more traditional options. With the Ontario climate giving a wide array of weather over the course of the year, it’s important that your roof is high quality, durable, reliable, and that doesn’t make your home look like a bunker. Steel roof panels are known for their durability and their ability to provide curb appeal. If you are considering installing a new roof on your residential home or commercial address, take a read through the following 7 advantages of a steel roof over other materials.

Red steel roof house

#1 Steel roof panels are a strong investment for your home.

It is not uncommon for steel roof panels to last as long as fifty years and beyond. The price of steel roof installation is a little more than traditional ceramic tiles but when one considers the costs of maintenance and roof replacement over time, the investment in a steel roof in Ontario is well worth it.

#2 Steel roofs are regularly coated to prevent corrosion and increase durability.

Galvanized steel roofing systems are pre-coated by the manufacturer in order to guard against corrosion and to provide a higher durability rating. The high quality paint finish as well doesn’t sacrifice beauty.

#3 It is possible to install a steel roof over an old roof.

If you are looking for a steel roof contractor in Ontario, know that it is possible to install a steel roof over an old roof thereby eliminating the costs and hassle associated with having to tear off the shingles. This is possible because steel is a very lightweight material that promises not to cause long-term structural bending either.

#4 Choose from a number of colours and styles for your steel roof.

There is an abundance of colors and styles to choose from as it pertains to a steel roof. The old traditional look of metal shingles can now be manufactured to imitate the look of slate, clay tile, cedar shake, and other looks. The diversity of the materials themselves means that steel or metal roof panels would suit any exterior.

#5 A steel roof is non-combustible and can protect against hurricane level winds.

In addition to being highly weather resistant, steel roofing is also non-combustible meaning that it will never catch on fire like asphalt roofs would. In addition, steel roof panels are wind resistant as well and are able to take winds up to hurricane level.

#6 Metal and steel roofs are the most durable materials to make your roof from.

Metal and steel does not rot, split, crack, dry out, chip, warp, or leak. These materials are not susceptible to termite or rodent infestation either. It’s not uncommon for metal or steel roofs to be able to withstand the impact from hail, sticks, and other circumstances.

#7 Metal and steel roofs require no maintenance.

It’s true. If installed correctly, you won’t need to perform any maintenance other than a minimal amount now and again. To clean it, simply use water. If exposed fasteners are being used, faster re-tightening may be required once every ten to fifteen years. Beyond that, there’s nothing else it needs.

These are just some of the advantages to steel roof installation. Be sure to browse through our product selection to get a better idea on what might be appropriate for your home or building.